← All gear
Bitfunx · Console Shells
Bitfunx Replacement Shell for NES
Nintendo Entertainment System — NES-001 front-loader — RCA / composite revision ONLY. Not the early RF-only units, not the NES-101 top-loader.
$50.51$81.00
- ✓Complete housing — shell, cartridge door, port trim
- ✓RCA / composite NES-001 boards only
- ✓Clear, purple, or smoke
- ✓No soldering — original hardware transfers over
A full transparent housing for the front-loading NES (NES-001): top and bottom shell, the flip-up cartridge door, and the small trim around the controller ports. Available in clear, translucent purple, and translucent smoke.
One thing to check before you buy: this shell is cut for the later NES-001 revision with the RCA composite jacks on the back. If your console only has the RF box, the rear cutouts won't line up. Otherwise it's a straightforward swap — no soldering, a handful of screws, about 30 minutes.
Specs
- Material
- ABS
- Compatibility
- NES-001 front-loader with RCA composite output
- Not compatible
- RF-only NES-001, NES-101 top-loader, Famicom
- In the box
- Top + bottom shell, cartridge door, port trim
- Tools needed
- Phillips #1 (not included)
- Install difficulty
- Beginner–Intermediate — ~30 min
GhostWire earns a commission on purchases made through the link above, at no extra cost to you.